Install a SmartWi system

1. Connect power to the Master box:

• Use the enclosed power-supply or a standard USB cable connected to your PC.

2. Do place the Master box:

• In the middle of the house, so the distance to all receivers (cards) are almost equal.
• In an upright position. New systems are delivered with a stand for this purpose.

3. Do not place the Master box:

• On top of your receiver or other metal sheets.
• Near a wireless LAN router or access point
• Near a DECT telephone or base station.

4. Insert subscription smartcard and check the green LED:

• Two short flashes
  • Card OK
• No light
  • Check power-supply
• Continuous slow flashing
  • Try and re-insert smartcard a couple of times
  • Download new firmware
• Led stays on
  • Restart box (remove power shortly)
  • Download new firmware

5. Read ATR

• Keep the smartcard in the Master box for 5 sec.

6. Prepare Client cards

• Insert a Client card into the Master box.
• The green LED flashes quickly
  • The Client firmware is updated
• The green LED flashes slowly
  • The Client card is ready and must be removed

7. Start system

• Insert smartcard into Master box
• Insert Client card into receiver

Notes:

• Start by testing if all your receivers are compatible with SmartWi, one by one. Place the Master box in the same room as the receiver, when you perform this test.
• On some receivers it is not possible to insert the Client card correct, due to the black plastic lid. You can then firmly remove the plastic lid, to make the Client fit correct. You do not break the product guarantee, when removing the plastic lid.